VGA display… On a 3″ scope tube!

Yes, you’ve all thrown away your lunky old CRT monitors, in favour of sleek ultra-thin LCD displays. And, you thought you’d never see another one again…

But this CRT display has a twist! It’s round. It’s small at just 3 inches diameter. And it’s awfully cute.

Oscilloclock 3-inch CRT VGA Display Assembly - overview

Last year, I was approached by a dedicated flight simulation enthusiast, who needed a radar indicator to use in a fighter cockpit replica. The indicator should employ a CRT, for the most realistic look. Could Oscilloclock design and construct such a display?

It didn’t take much convincing! Diverging only temporarily from building clocks, I took up the challenge to create my first raster-scan CRT display unit. In the ensuing months, difficulties sprang forth from every direction in the project, but ultimately I was able to avoid a diraster (sic) and deliver a functional assembly:

See more related videos on my YouTube channel

The Setup

The key component of this setup is a new prototype VGA Board that converts a VGA signal into analogue X and Y outputs. Both analogue intensity and binary blanking outputs are provided.

Oscilloclock VGA Board prototype

Oscilloclock VGA Board prototype

The X and Y outputs drive an Oscilloclock Deflection Board, while the binary blanking output drives the blanking amplifier in a CRT Board.

Oscilloclock Deflection Board - modified for ultra-linear HV output

Deflection Board – modified for ultra-linear HV output

CRT Board - heavily modified for improved frequency response

CRT Board – modified for improved frequency response

Blanking isolation, heater, and HV supplies are provided by a Power Board.

Power Board - with improved optocoupler

Power Board – with improved optocoupler

It all looks so easy! But noooo. Astute readers will recall from other posts that every Oscilloclock project involves sleepless slumbers, horrific hair-pulling, and forgotten family members. Let’s see what caused me grief this time…

Continue reading