Only just after I’d written last month’s post about an X-Y-Z display for an HUD, the customer asked for a spot of extra help with his new playtoy.
Uh oh – image not centred and way too big…
The Oscilloclock Deflection Board currently assumes X and Y input ranges of 0-5V, centred on 2.5V. However, the customer was programming an Arduino-based controller board with analogue output from 0-3.3V. Applying this directly of course didn’t break anything, but sure did make it hard to centre on screen! Would there be a quick way to adjust voltage levels?
Another issue was that the gain in the current-revision Deflection Board is hard-wired, and the image was not the right scale to just fit the screen. The gain could be changed via a single resistor per channel, but would there be an easier, more flexible way?
YES on both accounts!